Herrmann, JanJanHerrmannKoreck, JürgenJürgenKoreckMaess, MatthiasMatthiasMaessGaul, LotharLotharGaulEstorff, Otto vonOtto vonEstorff2023-11-012023-11-012011Mechanical Systems and Signal Processing 25 (3): 981-990 (2011)https://hdl.handle.net/11420/43958The integration of a model for longitudinal hydroacoustic fluid damping in thin hydraulic pipes in 3D finite element models is presented in this paper. In order to perform quantitative prediction of the vibroacoustic behavior and resulting noise levels of such fluidstructure coupled system due to hydraulic excitation, an accurate frequency-dependent fluid damping model including friction effects near the pipe wall is required. This step is achieved by matching complex wave numbers from analytical derivation into a parameterized damped wave equation and consecutive translation into finite element modeling. Since the friction effect close to the pipe wall changes locally with the inner pipe radius, the fluid damping model is applied segment-wise in order to model the influence of cross-sectional discontinuity, such as orifices, on the oscillating pressure pulsations. A component synthesis approach, which uses pipe segments as substructures, allows a simple model generation and fast computation times. The numerical harmonic results are compared to experimental frequency response functions, which are performed on a hydraulic test bench driven by a dynamic pressure source in the kHz-range.en1096-121620113981990ElsevierAcoustic fluidstructure interactionComplex circular wave numberFEMFluid dampingFluid-filled pipesSubstructuringPhysicsMathematicsJournal Article10.1016/j.ymssp.2010.09.013Journal Article