TUHH Open Research
Help
  • Log In
    New user? Click here to register.Have you forgotten your password?
  • English
  • Deutsch
  • Communities & Collections
  • Publications
  • Research Data
  • People
  • Institutions
  • Projects
  • Statistics
  1. Home
  2. TUHH
  3. Publication References
  4. Modeling of a thermomechanical process chain for sheet steels
 
Options

Modeling of a thermomechanical process chain for sheet steels

Publikationstyp
Journal Article
Date Issued
2013-05-06
Sprache
English
Author(s)
Barthel, C.  
Klusemann, Benjamin  
Denzer, Ralf  
Svendsen, Bob  
Institut
Kontinuums- und Werkstoffmechanik M-15  
TORE-URI
http://hdl.handle.net/11420/6470
Journal
International journal of mechanical sciences  
Volume
74
Start Page
46
End Page
54
Citation
International Journal of Mechanical Sciences (74): 46-54 (2013)
Publisher DOI
10.1016/j.ijmecsci.2013.04.006
Scopus ID
2-s2.0-84880572501
Publisher
Elsevier Science
The purpose of this work is the development, identification and validation of a model for the simulation of a thermomechanical multistage production process chain for sheet steels. The process of interest consists of forming (in particular deep-drawing) followed by cutting and heat treatment. For the forming and cutting stages, the complete model is based in particular on a model for thermoelastic, viscoplastic (i.e., rate-dependent) material behavior in sheet steels accounting for isotropic and anisotropic (i.e., kinematic and cross) hardening. This is combined with a model for thermally induced phase transformations in order to model heat treatment. The particular material modeled here is the sheet steel LH800®. This steel has an initially ferritic microstructure which is maintained during forming and cutting. Heating of the workpiece after forming and cutting during heat treatment phase results in transformation of ferrite to austenite. Subsequent air-cooling back to room temperature is accompanied by a second transformation from austenite to martensite. Model predictions for the workpiece behavior during forming and cutting show quite good agreement with corresponding experimental results. In contrast, small discrepancies between the model predictions and experimental results for the change in workpiece geometry during cooling imply that the phase transformation from austenite to martensite in LH800® is not purely volumetric in nature as assumed in the model. Rather, it results in change in the deviatoric state of stress in the material and a corresponding change in shape of the workpiece.
Subjects
Anisotropic hardening
Phase change
Rate dependence
Sheet steel
Thermomechanical process chain
DDC Class
600: Technik
620: Ingenieurwissenschaften
TUHH
Weiterführende Links
  • Contact
  • Send Feedback
  • Cookie settings
  • Privacy policy
  • Impress
DSpace Software

Built with DSpace-CRIS software - Extension maintained and optimized by 4Science
Design by effective webwork GmbH

  • Deutsche NationalbibliothekDeutsche Nationalbibliothek
  • ORCiD Member OrganizationORCiD Member Organization
  • DataCiteDataCite
  • Re3DataRe3Data
  • OpenDOAROpenDOAR
  • OpenAireOpenAire
  • BASE Bielefeld Academic Search EngineBASE Bielefeld Academic Search Engine
Feedback