3 results
Filters
Settings
Now showing1 - 3 of 3
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: with files , Thermal behavior of friction clutch disc based on uniform pressure and uniform wear assumptionsHigh temperatures appear in the contacting surfaces of a single-disc clutch system (friction clutch disc, flywheel and pressure plate) due to the relative motion between these parts during the sliding period. These high temperatures are responsible for several disadvantages such as increasing wear rate, surface cracks and permanent distortions. In some cases, these disadvantages may lead the contacting surfaces to failure before the expected lifetime. In this work, mathematical models of the friction clutch system (single-disc clutch) were built to find the temperature field during the sliding period (single engagement). Analysis has been completed using developed axisymmetric models to simulate the friction clutch system during the engagement. The surface temperatures are found based on uniform pressure and uniform wear assumptions.Publicationtype: Journal ArticleScopus© Citations 52 195 300 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: with files , Temperature analysis of a pin-on-disc tribology test using experimental and numerical approachesThe high thermal stresses generated at the interface between the contacting surfaces due to the sliding between parts of sliding system such as friction clutches and brakes. In this work, pin-on-disc test rig was built to find the temperature field during the sliding operation using experimental and numerical approaches. In the experimental approach, infrared camera was used to find the temperature distribution, while in the numerical approach a finite element technique has been used. Analysis has been completed using three-dimensional model to simulate a pin-on-disc system. The numerical results have shown a good agreement compared with the experimental results.Publicationtype: Journal ArticleScopus© Citations 41 288 379 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: with files , Damage due to rolling in total knee replacement : the influence of tractive force© 2013, The author(s). The femoral condyles of a knee prosthesis articulate with a combination of rolling and sliding on the tibial polyethylene plateau. Little is known about potential polyethylene damage due to rolling motion. Since rolling does not exclude the presence of tangential surface loads, this study sought to investigate the influence of tractive rolling on the wear of polyethylene. A “wheel-on-flat” apparatus, consisting of a metal wheel and a polyethylene flat, mimicked contact conditions present in total knee replacement. An increasingly tractive force under conditions of pure rolling was applied. It was found that under rolling kinematics a tangential surface load of up to 17% of the normal load could be transferred through the contact. Surface damage was dependent on the amount of tractive force and appeared more severe with higher forces. In the region of highest tractive force, wear features were identified that resembled perpendicular ridges on surfaces of retrieved tibial polyethylene devices. This suggests that tractive rolling may be a relevant wear mode in total knee replacement.Publicationtype: Journal ArticleScopus© Citations 11 274 255