Now showing1 - 2 of 2
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: without files , Reductive precipitation and removal of Cr(VI) from groundwaters by pipe flocculation-microfiltrationChromium (Cr(VI)) is a very toxic and carcinogenic element, which is widely present in groundwaters, mainly due to geogenic conditions. The limit of Cr(VI) in drinking water is expected to be reduced to 10 μg/L in both the USA and the European Union. Recent literature findings indicated that the most efficient process in reducing Cr(VI) levels to below 10 μg/L proved to be Cr(VI) reduction by Fe(II), by applying a molar ratio Fe(II)/Cr(VI) of around 9. In the present work, we investigated the reduction of Cr(VI) by Fe(II) in pipe flocculation reactors followed by filtration of insoluble products by microfiltration. The proposed technology involves re-circulation of a part of the sludge in the pipe reactors, in order to improve kinetics and efficiency of the process. The obtained results showed that with a Fe(II) dose of around 1 mg/L, Cr(VI) was reduced to below 10 μg/L, by even an initial concentration as high as 300 μg/L of Cr(VI), corresponding to a molar ratio Fe(II)/Cr(VI) of around 3, thus reducing the overall quantity of reductive reagents and of the produced sludge. This ratio was also confirmed by the XPS analysis, which also showed that Cr(VI) was reduced to Cr(III) and then precipitated either as Cr(OH)3 or associated with the produced iron oxides.Publicationtype: Journal Article134 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: without files , Impact of O₃ or O₃/H₂O₂ treatment via a membrane contacting system on the composition and characteristics of the natural organic matter of surface watersThe present study aims to evaluate changes in the structure-composition of natural organic matter (NOM) that occur after the application of bubbleless ozonation or peroxone treatment of surface waters. The oxidation experiments (using 0.5–2 mg O₃/mg DOC, or 2:1 O₃:H₂O₂ molar ratio) were performed in a continuous mode, using a tubular ceramic membrane contactor. Fluorescence spectroscopy (emission-excitation matrix) and liquid chromatography-organic carbon detection (LC-OCD) were mainly used for the detailed DOC characterization. In brief, the application of single ozonation resulted to high reduction of humic-like peak fluorescence intensities (50–85%) and also to the formation of two new peaks in the region of protein-like components. The co-addition of H2O2 did not present the anticipated increase in the reduction of fluorescence intensity; however, it resulted to the further oxidation of protein-like fluorophores. LC-OCD measurements confirmed the decrease of average molecular weight of NOM during ozone treatment, due to the gradual degradation of biopolymers (14–23%) and humic substances (11–17%) towards building blocks and low molecular weight (LMW) neutrals. Advanced oxidation process (AOP) treatment by the mixture O₃/H₂O₂ resulted in the simultaneous decrease of building blocks and LMW neutral concentrations. Conventional batch ozonation and AOP experiments were conducted using ozone-saturated solutions to investigate the effect of different contacting patterns. The results revealed that the different reaction pathways followed during bubbleless and conventional batch experiments may also influence the formation of NOM oxidation intermediates.Publicationtype: Journal Article163