2 results
Now showing1 - 2 of 2
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: without files , Role of nanoimprint lithography for strongly miniaturized optical spectrometersOptical spectrometers and sensors have gained enormous importance in metrology and information technology, frequently involving the question of size, resolution, sensitivity, spectral range, efficiency, reliability, and cost. Nanomaterials and nanotechnological fabrication technologies have huge potential to enable an optimization between these demands, which in some cases are counteracting each other. This paper focuses on the visible and near infrared spectral range and on five types of optical sensors (optical spectrometers): classical grating-based miniaturized spectrometers, arrayed waveguide grating devices, static Fabry–Pérot (FP) filter arrays on sensor arrays, tunable microelectromechanical systems (MEMS) FP filter arrays, and MEMS tunable photonic crystal filters. The comparison between this selection of concepts concentrates on (i) linewidth and resolution, (ii) required space for a selected spectral range, (iii) efficiency in using available light, and (iv) potential of nanoimprint for cost reduction and yield increase. The main part of this review deals with our own results in the field of static FP filter arrays and MEMS tunable FP filter arrays. In addition, technology for efficiency boosting to get more of the available light is demonstrated.Publicationtype: Journal Article39 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: without files , Determination of the saturation length and study of its effects in optical gain measurements of organic semiconductors using the variable stripe length method(American Institute of Physics (AIP), 2019-10-21); ; ; ; Three indicators for the determination of the saturation length limiting the validity of the variable stripe length method are presented. Depending on the maximum stripe length being used for the nonlinear fit, the resulting modal gain, its confidence interval, and the spectral full width at half maximum vary and give clear indications on the saturation length. Exemplarily, a blend of organic semiconducting spiro-compounds has been measured to present the importance of this length and demonstrate its determination. Subsequently, the optical modal gain is calculated with consideration of the saturation length. Both the saturation length and modal gain are shown to be dependent on the pump energy but result in a constant gain-length product of 2.2 ± 0.2, independent of the pump energy. Additionally, spectral gain profiles for different pump energies are presented with a maximum net modal gain of (128 ± 4) cm - 1 found at (2.98 ± 0.09) mJ / cm 2.Publicationtype: Journal Article56